Wrecker truck manufacturers Tell your small wrecker work Procedure

China tow truck manufacturers
Small Wrecker job step:
    1. disengage the winch clutch, pull the rope before being carried into the vehicle, the "j" hook line hook end lower portion of the cargo vehicle towed towing shackle. Then winch clutch engagement.
Note: When pulling rope rope laps remaining not less than 5 laps
2. The vehicle carrying the neutral gear, release the cargo vehicle parking brake.
3. winch control lever, pull the car platform and control j-hook from the winch cable is greater than 0.4m
Note: When a load on the winch, do not hand winch control clutch is disengaged! ! This will damage the winch.
Note: The use of a chain hook winch pulling the car accident, in particular chassis than the end of the car, you want to be very careful not to damage the trailer parts, in order to avoid unnecessary trouble.
4. When the vehicle is loaded in place has dragged on, with security straps tied after the tires, the car will be loaded back on both sides of the diagonal tension on both sides of the plate fixed to the pull ring. Note: If the Security tab is broken, the safety straps should be wound on a solid car parts. For security can not be manually locked bandage, can manipulate public capstan winch lever close embrace the loading vehicle to move forward a little so that the safety chain properly tensioned.
5. plate with fixed straps fault car must be locked in a four wheel straps or body.
6. The straps must be closed when the locking ratchet.
NOTE! ! : Long nylon straps taut appear loose, the operation should regularly check the bandage tight situation, especially in poor road conditions or sudden braking more cases, should be checked tightened to avoid accidents.
7. Move the joystick control platform, so that the rear platform raised off the ground 0.15m.
8. Move the joystick control platform, to enable the platform to move forward from the forefront of about 0.6m, the control platform tilt the joystick to make the platform back to a horizontal position.
9. Slip the joystick control platform, the platform is moved forward to the front.
10. In order to prevent the next running of the process, due to destruction of shock, tension on the winch cable may cause, must be fixed in accordance with the aforementioned method front of the vehicle, and the tension as much as possible with the other two safety chains. Load positioning and taut.
11. Cars will be loaded first gear, handbrake.
12. Check all safety chain or belt and chain connection is solid and tensioned.
13. After the above steps are completed, that is, and subsequent work program. Depress the clutch wrecker, disengage PTO, platform loading operation is completed.
China wrecker truck manufacturers